• Apple-13632793113
  • Vivi-18038057749
Email:sales09@sunsoartech.com Shenzhen Sunsoar Tech Co.,Ltd

Shenzhen Sunsoar Tech Co.,Ltd

Product Categories
Contact Us

Sunsoar Tech

4F, E block, Nanchang Huafeng
The Second Industrial Zone
Hangkong Road, Xixiang Town
Bao'an District, Shenzhen City
China


Contact Information 

Tel: +86 755-82956801

Mob: +86 136 3279 3113

Fax: +86 755-82954160

Email: sales@sunsoartech.com

Web: www.sunsoartech.com

LED circuit-Basic circuit-circuit board pcb

LED circuit-Basic circuit-circuit board pcb

LED circuit

Simple LED (Light Emitting Diode) circuit diagram

In electronics, an LED circuit or LED driver is an electrical circuit used to power a light-emitting diode (LED). The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED. The voltage drop across an LED is approximately constant over a wide range of operating current; therefore, a small increase in applied voltage greatly increases the current. Very simple circuits are used for low-power indicator LEDs. More complex, current source circuits are required when driving high-power LEDs for illumination to achieve correct current regulation.

Basic circuit

The simplest circuit to drive an LED consists of a voltage source and two components connected in series: a current limiting resistor, sometimes called the ballast resistor, and an LED. Optionally, a switch may be introduced to open and close the circuit. Although simple, this circuit is not the most energy efficient circuit to drive an LED, since energy is lost in the resistor. More complicated circuits improve the energy efficiency.

An LED has a voltage drop specified at the intended operating current. Ohm's law and Kirchhoff's circuit laws are used to calculate the appropriate resistor value to obtain the desired current. The value is computed by subtracting the LED voltage drop from the supply voltage, and dividing by the desired operating current. If the supply voltage is equal to the LED's voltage drop, no resistor is needed.

This basic circuit is used in a wide range of applications, including many consumer appliances such as mobile phone chargers.


Professional Manufactur Custom Design Circuit Board Electronic Pcb


Copyright © Shenzhen Sunsoar Tech Co.,Ltd. All rights reserved.
QR Code

Shenzhen Sunsoar Tech Co.,Ltd

[[Html_Custom]]